4U Modular Power Distribution Board

from $12.99

This is a 4U format power distribution PCB but is compatible with Serge, MOTM, CGS, MFOS, Frac, BugBrand, Slightly Nasty, or other format of modular that uses 0.156” Molex style headers. Conforming to the 6”x1” Serge PCB standards, it will fit into your panel projects and allow for simple power distribution.

Assembled / DIY:

This is a 4U format power distribution PCB but is compatible with Serge, MOTM, CGS, MFOS, Frac, BugBrand, Slightly Nasty, or other format of modular that uses 0.156” Molex style headers. Conforming to the 6”x1” Serge PCB standards, it will fit into your panel projects and allow for simple power distribution.

AMP/Molex connector part number: 640445-4

4P connector pinout:
Pin 1 : -V
Pin 2: GND (Earth)
Pin 3: GND
Pin 4: +V

*Be mindful of if your modules require +/-12V or +/-15V. This power distribution board can handle either, but not both at the same time.
Most modules can be adapted from +/12V to +/-15V with minimal resistor changes. You’ll have to check the build documentation for those modifications.